The Ammonium Flow Cell ISE from EDT directION is a solid state, zero dead volume sensor that can be used independently or positioned in series to create a multi-element sensor system. A reference flow-cell is required for each set of flow cells. The ideal flow rate is around 1-10ml per minute using a peristaltic pump. The Flow Cell has an ID of 2.3mm.
- Zero dead volume
- Solid state
- Fast response
- Long lifetime
- Unlimited shelf life
These sensors are ideal for Flow Injection Analysis (FIA) or for situations where continuous monitoring is required. Measurements can be made in zero flow as required in stop/flow or static measurements.
The assembled sensor block (holder and flow cells) is approximately 20x50mm. Cells can be interchanged at will without disconnecting the tubing.
The Ammonium sensor is in the form of a small solid state Acrylic block with a bore diameter of 2.3 mm. A flow through reference is required for operation (Part No 4001). These small ISEs have exactly the same specifications as the standard Ammonium ISE (Part No 1051) but has further advantages such as: Zero dead Volume, Large sample contact area, low sample volume (min 50 microliters), easy cleaning.
The EDT Ammonium Flow Cell has unlimited shelf life. Supplied with O rings, 1 metre cable with BNC connector. Requires reference flow cell (Part No 4001), flow cell holder (Part No 4443). Tubing and pump not supplied.
The EDT Flowcell holders are constructed from Aluminium with Stainless steel fittings. Standard holders accept 1,2or 3 modules plus a reference Flowcell EDT direction produce standard solutions and ISABs for all ISE analysis.
Specification is the same as Ammonium Half cell ISE Cat no. 1051.
Watch a calibration video by clicking here.
Additional information
Dimensions | 30 × 14 × 14 cm |
---|---|
Bore Diameter | 2.3mm |
Flowcell Width | 9mm |
Dead Volume | Zero |
Material | Acrylic |
Connector | 2mm Pin |
Minimum Cell Volume | 50 Microlitres. (200 with reference) |
Commodity Code | 90279050 |
Reviews
There are no reviews yet.